bladox.com Forum Index bladox.com
Turbo SIM Toolkit Adapter Forums
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

turbo-info error

 
Post new topic   Reply to topic    bladox.com Forum Index -> General
View previous topic :: View next topic  
Author Message
LLcoolR



Joined: 02 Jan 2008
Posts: 3

PostPosted: Wed Jan 02, 2008 10:58 am    Post subject: turbo-info error Reply with quote

i tried to fit the turbosim and the at&t-sim as good as possible. i only see "no sim" in the upper left corner of the springboard.

after typing turbo-info in winscp terminal i always get this error:

/bin$ turbo-info
initializing modem
AT+CPMS="SM","SM"
AT+CPMS="SM","SM"
ERROR
AT+CMGF=0
AT+CMGF=0
ERROR
AT+CPMS?
AT+CPMS?
ERROR
modem initiated
Mobile Phone/Serial Cable Communication Error

what can I do now?? any hints?? i do not know any further ... please help me in this case.

Thank you all!
Back to top
View user's profile Send private message
matthew81



Joined: 04 Jan 2008
Posts: 1

PostPosted: Fri Jan 04, 2008 10:55 am    Post subject: Reply with quote

i have the same problem!!

my iphone is a 1.1.2 OOTB with bot 4.6

- downgrade to 1.1.1
- installed bsd subsystem, open ssh, community sources
- copyed files folder "turbosim" on the root of iphone, setup all files on 0755
- i have restarted iphone with Turbosim + Sim aT&t
- when i tupe "turbo-info" the phone answer so:

# ./turbo-info
initializing modem
AT+CPMS="SM","SM"
ERROR
AT+CMGF=0
ERROR
AT+CPMS?
ERROR
modem initiated
Mobile Phone/Serial Cable Communication Error

why?? help me please!
Back to top
View user's profile Send private message
LLcoolR



Joined: 02 Jan 2008
Posts: 3

PostPosted: Fri Jan 04, 2008 11:31 pm    Post subject: Reply with quote

finally i got it!!!!!! my iphone works with turbosim

just try to fit the turbosim as good as possible on the at&t sim!!!



you can also check if your turbosim is on its correct place (when "commcenter" is enabled!):

take out the original sim - "no sim" should pop up
now put the (not yet programmed) turbosim on the at&t-sim and insert the whole slot back into the phone

now "no sim" should swap to "...."

may the force be with you!! good luck!!
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    bladox.com Forum Index -> General All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group