| View previous topic :: View next topic |
| Author |
Message |
usvi4me
Joined: 04 Jan 2008
Posts: 1
|
 Posted: Fri Jan 04, 2008 8:15 pm Post subject: AT&T Activated iPhone question |
 |
|
I have an AT&T activated 1.1.2 OTB iPhone jailbroken. (week 47)
I purchased on eBay a New Cingular Wireless AT&T 64K 3G Sim Card since I did not want to cut up the original AT&T activated iPhone sim I'm using when stateside.
I followed all directions to set up the iPhone with use off the Turbo Sim.
I have the following challenge:
When using the non-at&t sim with the turbo-sim,
1) the signal bar shows up with no signal showing
2) no carrier shows up
3) The turbo sim apps show up in the phone settings
4) The non-att&t sim's phone number shows up at the top of the contact list.
5) The non-at&t sim works fine in another phone.
Because of 3 and 4 I believe all the software is installed properly.
When I put the iPhone activated at&t sim back in, all works fine and the turbo-sim applications disappear from the settings.
Could the non-signal issue be that I used an incorrect non activated at&t sim ?
As always, any suggestions are greatly appreciated. |
|
| Back to top |
|
 |
Nekos
Joined: 16 Dec 2007
Posts: 31
|
| Posted: Sat Jan 05, 2008 1:02 pm Post subject: |
|
|
Hi...
did you run Applesaft and SET the parameters ? |
|
| Back to top |
|
|
A3Australia
Guest
|
| Posted: Sat Jan 05, 2008 1:36 pm Post subject: Re: AT&T Activated iPhone question |
|
|
| usvi4me wrote: | I have an AT&T activated 1.1.2 OTB iPhone jailbroken. (week 47)
I purchased on eBay a New Cingular Wireless AT&T 64K 3G Sim Card since I did not want to cut up the original AT&T activated iPhone sim I'm using when stateside.
I followed all directions to set up the iPhone with use off the Turbo Sim.
I have the following challenge:
When using the non-at&t sim with the turbo-sim,
1) the signal bar shows up with no signal showing
2) no carrier shows up
3) The turbo sim apps show up in the phone settings
4) The non-att&t sim's phone number shows up at the top of the contact list.
5) The non-at&t sim works fine in another phone.
Because of 3 and 4 I believe all the software is installed properly.
When I put the iPhone activated at&t sim back in, all works fine and the turbo-sim applications disappear from the settings.
Could the non-signal issue be that I used an incorrect non activated at&t sim ?
As always, any suggestions are greatly appreciated. |
I reckon you activated with the AT&T SIM so there is a lockdown file on the iPhone with that AT&T SIMs info.
You would have to Virginize the iPhone - then go through all the usual steps to get to 1.1.2 and Jailbreak and Activate. Then you can use your TurboSIM with your SIM of choice.
A3 Australia |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
